Powerjet controller - Yamaha injection system setting yfm 700 r as well as all models yfz 700 r / se /. The Yamaha Yfm 700 r injection engine is very lean, and that's very good.Unless you are a demanding driver and you want maximum performance in allen speed ranges, or e. A tuning or similar exhaust.
The ability to simply change the air-fuel ratio for these conditions so that you can easily adjust it to the maximum of yourself without compromising reliability would be wonderful, wouldn't it? The powerjet controller now does exactly that with your yamaha yfm 700 r, wonderfully without compromising reliability, right? You can adjust the fuel injection from -4% to + 10% compared to the intake air. The 10 pre-programmed settings are immediately available for this! The settings were developed and developed accurately on the test bench and tested later during driving.
We even have a parameter that means no change, that is, that represents the original state. So, you always have the exact comparison with the original setting!
Our powerjet controller is very easy to use. The powerjet controller itself, however, is very complicated to develop and run!The power jet controller must always do several things and measures at the same time. It measures the outside temperature at the sensor level and records the signal of the original temperature sensor for the original ecu (electronic injection controller). The power jet controller then converts the intake air temperature with the respective correction factor and sends this signal to the shield later.
According to the adjustment, the ecu, i. The information that the intake air is a little colder than it really is. From the ECU due to the optimized control, the fuel is injected into the respective speed range in a quantity of fuel proportionally higher than the intake air. You will have a much better answer when giving gas and speeding up the engine notice!What is good is that if the oxygen sensor in the exhaust system signals a constant charge (constant speed), it gives the power jet controller the signal to the ecu to control the fuel-to-air ratio as in the original state with a reduced poor injection. The power jet controller is therefore a very intelligent electronic device that also ensures that fuel consumption does not increase unnecessarily! But as soon as the power jet controller if there is an increase in performance, it switches from the closed loop (return of the oxygen sensor) to the modified control and opens again the modified fuel/air ratio.
The powerjet controller however, it is very easy and quick to install! By plugging into the original connector of the temperature sensor and the ecu cable, the installation is ready in a few minutes. The plugs of the power jet controllers conform to their original plug. So you don't need to adjust or make any changes.So quickly and quickly installed ready to roll! All powerjet controller people comes with the exact plug-ins for your. All powerjet controller people comes with the exact connections for your models with connection plug and connection cable. Powerjet injection system controller particularly suitable for: yamaha yfm 700 r yfz700 raptor 700 r / se / models: yfm700rv (1s31), rspv (1s34), rw (1s37), rsew (1s3a), rse2w (1s3e), ryrw (1s3d), rsp2x (1s3s), rspx (1s3m), rx (1s3h). Customers who bought this product also bought.
set of chains for yfm.. set of chains for yfm7...luggage rack / suitcase / bag. Set of chains / pinion / chain.
Tires / rims / wheel bearings. Fuel cap - fuel parts.
Winter / Snow blades / work. Powerjet injection system controller particularly ada. Cdi / ECU tuning modul. This item is in the category "Car, motorcycle - parts, accessories\quad, trike : parts". The seller is "motorrad-goetz" and is located in this country: de.
This item can be shipped to the following countries: European Union, Switzerland.