If you have any questions, please feel free to contact us. PowerJet Controller Yamaha YFM 700 R CDI ECU Tuning. PowerJet Controller - tuning of the Yamaha YFM 700 R injection system and all YFZ 700 R/SE models. The injection engine of the Yamaha YFM 700 R runs very lean, and that's fine.
Unless you are a demanding driver and want maximum performance in all speed ranges, or for example a tuning exhaust or similar. The ability to simply adjust the fuel/air ratio here for these conditions so that you can easily adjust it to the maximum you want without sacrificing reliability would be wonderful, wouldn't it? The PowerJet controller now does exactly that with your Yamaha YFM 700 R without sacrificing reliability - wonderful, isn't it?
You can adjust the fuel injection from -4% to +10% compared to intake air. The 10 preprogrammed settings are immediately available to you! The settings have been precisely developed and developed on the test bench, and then tested while driving. We even have a setting that means no change, i. So you always have the exact comparison with the original setting! Our PowerJet controllers are very easy to use.The PowerJet controller itself is very complicated in development and execution! The PowerJet controller always has to do several things and measurements at the same time. It measures the outside temperature at the sensor and picks up the signal from the original temperature sensor for the original ECU (electronic injection controller). The PowerJet controller then converts the intake air temperature with the respective correction factor and transmits this signal to the ECU.
Depending on the setting, the ECU receives the information that the intake air is a little cooler than it actually is. The ECU, thanks to the optimized control, will inject a proportionally higher amount of fuel relative to the intake air in the respective speed range. You will notice a much better response when driving and accelerating the engine! The great thing is that if the oxygen sensor in the exhaust pipe signals under constant load (constant speed), the PowerJet controller signals to the ECU to control the fuel/air ratio as in the original state with reduced lean injection. The PowerJet controller is therefore a very intelligent electronic device that also ensures that fuel consumption is not unnecessarily high! But as soon as the PowerJet controller notices an increase in performance, it switches from closed loop (oxygen sensor feedback) to modified control and opens up the modified fuel/air ratio again.Installing the PowerJet controller, on the other hand, is very simple and quick! By plugging in the original plugs of the temperature sensor and the ECU cable, the installation is completed in a few minutes. The Power Jet controller plugs fit your original socket. So quickly installed and ready to go! Each PowerJet controller comes with the exact plug connections for your.
Each PowerJet controller comes with the exact connectors for your models with connection plug and connection cable. PowerJet injection system controller particularly suitable for: Yamaha YFM 700 R YFZ700 RAPTOR 700 R/SE/models: YFM700RV (1S31), RSPV (1S34), RW (1S37), RSEW (1S3A), RSE2W (1S3E), RYRW (1S3D), RSP2X(1S3S), RSPX(1S3M), RX(1S3H). Customers who bought this product also bought. Chain set / sprocket / chain. Accelerator handlebar switch throttle trains.
Oils, care products & lubricants. Fuel cap - fuel parts. PowerJet injection system controller particularly suitable for.